Genuine Vornado Filters - Vornado AC300-EU Manuel D'utilisation

Filter Replacement
4. Remove and discard used Filters. Simply take hold of the
Carbon Filter at any place along the perimeter and remove.
To remove the HEPA Filter, take hold of the tab (Figure 1)
and pull to release. Replace with genuine Vornado Filters.
Place the Filters in the unit and gently press around the pe-
rimeter of the Filter to ensure secure placement (Figure 2).
Fig. 1 Fig. 2
10 English
5. Replace the Plastic Support Filter Frame by securing the
bottom 2 tabs into bottom slots (B). Slightly flex the Plastic
Support Filter Frame to secure the top 2 tabs into the top
slots (A).
A
A
A A
A
B B
B
B
B
6. Replace Front Panel by positioning the Panel slightly above
the unit and aligning the tabs of the Front Panel with the
holes in the unit (A). Gently press the Front Panel down,
sliding into the tab slots and allowing the magnets to se-
curely lock the Front Panel in place.
A
±
±
Safety Shut-Off Feature
For your protection, the unit is designed to operate only if the
Front Panel is in place. Do not attempt to override this safety
feature. If, after the Front Panel has been removed, the unit
does not operate, remove and reinstall the Front Panel to as-
sure proper placement.
Filter Replacement
7. To reset the Replace Filter notification - press and hold the
REPLACE CARBON or REPLACE HEPA button, depending
on which filter was replaced, for at least 3 seconds. The light
will turn off confirming the indicator is reset.
Press for 3 seconds
Note: Do not operate the Air Purifier without Vornado Carbon
and Vornado HEPA Filter in place.

Genuine Vornado Filters

Peak performance is only realized when genuine Vornado
Carbon and HEPA filters are used. Others may claim to be
compatible with Vornado units, but the Vornado Air Purifier
is calibrated to achieve a 99.97% capture rate of particles
0.3 microns or larger, only when used with Vornado Filters.
Carbon Filter HEPA Filter
Part # MD1-0012 Part # MD1-0011
English
11