Possible Errors; Warranty And Responsibility; Battery Replacement - LEVELFIX CL 200 Série Manuel D'utilisation

EN
MAINTENANCE
• Handle measuring devices with care.
• Clean the device after every use with a soft cloth. If
nessesary, dampen the cloth with water.
• If the instrument gets wet, clean it and dry it carefully.
• Only put the laser away when it is completely dry.
• Remove the batteries and rechargeable batteries when
switching off the aser for a long time.
• Do not use solvent to clean the laser.
• Only transport the laser in its original case.
The CPL100 series line laser is not watertight or
airtight. Do not get it wet, as this may damage
the internal circuits. Do not leave it in direct
sunlight or exposed to high temperatures. The laser body and
some internal parts are made of plastic and can warp at high
temperatures. Do not store the laser in a very cold environment,
as this can cause condensation to form on the internal
parts when the laser is warmed up. This can mist up the beam
windows and cause the internal circuit boards to rust.

POSSIBLE ERRORS

If the measurements calculated by the laser are incorrect, this
could have been caused by:
• Using the laser near to plastic or glass windows (may give
false information).
• A dirty or obstructed beam window.
• A slight movement of the device. If this is the case, check
the precision of the device once more.
• Signifficant temperature diffrences: if the laser is used
in a cold environment after being stored in a warm envi-
ronment, wait a few minutes for the laser to reach room
temperature before carrying out any measurements.
20

WARRANTY AND RESPONSIBILITY

The device has a two-year warranty. This warranty does not
cover breakdowns or faults which may have been caused by:
• Incorrect use of the device.
• Non-respect of the instructions described in the user-
manual.
• Offcuts, poor handling, use of unsuitable batteries, poor
electrical connections etc.
Repairs made other than by our factory, our service centres
or authorized service stations relieve our company of further
liability under this guarantee. This warranty is made expressly
in place of all other warranties, expressed or implied, with
respect to quality, merchantability, or fitness for a particular
purpose.
THE USER MUST CHECK THE DEVICE
REGULARLY AND BEFORE CARRYING OUT
SUBSTANTIAL WORK.
Levelfix company shall accept no responsibility for problems
regarding the construction, installation, manufacture
or assembly which may result from a machine failure due to
poor maintenance of the device or hazardous connections to
other devices.

BATTERY REPLACEMENT

When the LED 9 ( fig 2) flashes red, this means that the battery
level is low and that the batteries need to be replaced.
The CPL200 series laser uses 3 AA batteries.
Open the cover (underneath the laser) and insert the 3 batteries
according to the instructions given inside the compartment.
Close the cover.