Using The Device - Atlantic DORIS Notice D'utilisation Et D'installation

CASE OF THE MIXED VERSIONS WITH FAN
Description of the lower part of the device.
C
Service pressure must not exceed 4 bar.
Use on electricity
SUMMER SETTING
The central heating circuit is
not working.
Use on central heating
WINTER SETTING
The central heating circuit is
working.
Using the bleeder, make sure that the device is correctly filled. If, when you open the bleeder, the
water does not flow regularly, please contact your fitter.
It is forbidden to leave A switch on l when the supply tap C is open. This abnormal use causes can-
cellation of the warranty.
The use of this device without water would lead to the definitive deterioration of the resistor. This
incident would definitely require its replacement, which is not covered by the Maker's guarantee.
The boiler return tap D must obligatorily remain open, even in the case of the SUMMER SETTING
in order to allow expansion of the fluid in the circuit so as to avoid any damage to the device.
U
SING THE DEVICE
A
B
C
D
B
D A
- A switch is on I.
- The B indicator light is ON, the heating resistor incorporated in
the device is supplied.
- The supply tap C must be closed.
- The boiler return tap D must remain open.
- A switch is on O.
- The B indicator light is OFF, the heating resistor incorporated in
the device is not supplied.
- The supply tap C must be open.
- The boiler return tap D must remain open.
WARNING
21
Switch to control the heating resistor incor-
porated in the device.
Indicator light to check the operating status of
your device.
Supply tap to allow inlet of hot water from the
central heating. This can be thermostatically
controlled or not depending on your choice.
Boiler return tap to allow the hot water to
leave the central heating.