BERTO'S PLUS 600 Série Mode D'emploi page 43

The models with double griddles are equipped with
two cooking areas with separate controls to adjust
temperature independently.
To switch the unit off, rotate the handle to the
position.
GRIDDLE OPERATION
PYROCERAM GRIDDLE
Make sure the gravy collecting tray is positioned
correctly.
Activate the main switch before the appliance.
To switch on the unit, rotate the handle of the chosen
cooking area, the light will switch on to indicate the
unit is operating.
The whole griddle area is heated.
We recommend switching on the plate to the maximum
temperature, and as soon as it is reached, rotate the
handle to the desired position. Each area is switched
off by rotating the handle to the
GLASS CLEANING
Glass must be cleaned with liquid degreasing detergents
based on vinegar or lemon and suitable to clean china and
glass. During this operation, we recommend the glass is not
completely cold, so that food residue, burnt fat and other,
can be softened by a damp cloth and removed by a scraper
in order to preserve the surface.
Do not use abrasive or corrosive detergents.
WARNING
The cooking surface is resistant but not unbreakable and
might be damaged by hard or sharp objects that might fall
onto it. If there are cracks, dents or cuts, do not use the unit
and contact Service Assistance immediately.
Do not pour water on the pyroceram surface especially
when it is still hot, it may damage the surface.
MAINTENANCE
CARE OF THE APPLIANCE
ATTENTION!
- Before cleaning, switch off the unit and let it cool down.
- In the event of electrically supplied units, use the
isolator switch to disconnect the mains.
Carefully clean daily the appliance to guarantee its proper
operation and long life.
Steel surfaces must be cleaned with a dish washer
detergent diluted in very hot water by using a soft cloth;
for the toughest dirt, use ethylic alcohol, acetone or
another non-halogenated solvent; do not use abrasive
powder detergents or corrosive substances such as
hydrochloric acid, muriatic or sulphuric acid. The use
of acids can affect the unit's operation and safety. Do
not use brushes, steel cottons or abrasive disks made with
other metals or alloys that might cause rust stains due to
contamination. For the same reason, avoid contact with
iron objects. Do not use steel cottons or stainless steel
/
brushes because whilst they will not contaminate surfaces,
they can cause damaging scratches.
If dirt is tough, do not use sandpaper or rough paper, but
use synthetic sponges (for example Scotchbrite sponges).
Do not use substances for cleaning silver and be careful
with hydrochloric or sulphuric vapours coming from floor
washing products, for example. Do not aim water jets
directly on the appliance, it might be damaged. After
cleaning, rinse properly with clean water and dry carefully
with a cloth.
IMPORTANT
To use the pyroceram tops at their best, follow the
recommendations and instructions:
1) after cooking remove all dirt and food residuals from
/ position.
2) pour a few drops of a detergent suitable for pyroceram
3) Rinse the surface well and dry with a soft cloth or
We recommend cleaning after every use.
COMPONENT REPLACEMENT (SPARE PARTS)
Use only original spare parts supplied by the
manufacturer.
All maintenance must be carried out by a qualified person.
Complete appliance service at least once a year. We
recommend subscription to our maintenance agreement.
LONG PERIODS OF INACTIVITY OF THE APPLIANCE
If the appliance is not used for long periods of time, please
observe the following:
1) switch off the isolator switch to disconnect the mains.
2) clean the equipment and the surrounding areas
3) pour a small quantity of cooking oil on the stainless
4) carry out all maintenance operations
5) cover all appliances with a suitable material and leave
In the event of a failure, disconnect the appliance immediately
from the mains and contact for Service Assistance.
the surface by using a proper scraper.
surfaces on the cold surface and rub with kitchen paper
or a soft cloth. Do not use sponges or any type of
abrasive products. As well as corrosive detergents
such as oven spray or stain removers.
kitchen paper.
properly
steel surfaces and on the griddle
few openings to allow air to circulate
WHAT TO DO IN THE EVENT OF FAILURE
| 43
EN