Information On Display Panel; Temperature Problem; Noise - Siemens iQ500 GI V Série Notice D'utilisation

en Troubleshooting

Information on display panel

Fault
The temperature display
flashes and a warning signal
sounds.

Temperature problem

Fault
The temperature differs
greatly from the setting.

Noise

Fault
Appliance has a humming
sound.
The appliance bubbles,
buzzes or gargles.
The appliance clicks.
The appliance makes
noises.
50
Cause
Different causes are pos-
sible.
The appliance door is open.
The ventilation openings are
covered up.
Larger quantities of fresh
food have been put in.
Cause
Different causes are pos-
sible.
Cause
Not a fault. A motor is run-
ning, e.g. refrigerating unit,
fan.
Not a fault. Refrigerant flows
through the pipes.
Not a fault. Motor, switches
or solenoid valves are
switching on or off.
The appliance is not level.
Fittings wobble or stick.
Containers are touching.
troubleshooting
Press .
▶
a The alarm is switched off.
Close the appliance door.
▶
Remove any obstructions from in
▶
front of the ventilation openings.
Do not exceed the max. freezing ca-
▶
pacity.
→ "Freezing capacity", Page 44
troubleshooting
Switch off the appliance.
1.
→ Page 42
Switch the appliance back on after
2.
five minutes. → Page 42
If the temperature is too
‒
warm, check the temperature
again after a couple of hours.
If the temperature is too cold,
‒
check the temperature again
on the following day.
troubleshooting
No action required.
No action required.
No action required.
Align the appliance using a spirit
▶
level. If required, place something
underneath it.
Check the removable fittings and, if
▶
required, replace these.
Move the containers apart.
▶