Dubbing An Md (Md Synchro-Recording) - Sony MDS-W1 Mode D'emploi

Dubbing an MD
1
STANDBY
A OUTPUT B
PHONE LEVEL
)
0
PHONES
·
P
The MD Synchro-Recording
Function lets you dub an MD in
deck A to an MD in deck B.
When you want to dub from
deck B to deck A, see
"Recording on an MD" on
page 7. In this case, the MD is
dubbed by normal recording
instead of MD Synchro-
Recording.
z
There are three methods for
dubbing an MD
• You can copy all tracks from
deck A to deck B.
(All Tracks Dubbing)
• You can copy a single track
from deck A to deck B.
(One Track Dubbing)
• You can copy only the
programed tracks from deck
A to deck B.
(Program Dubbing)
Notes
• When you copy all tracks, use a
recordable MD that has enough
time remaining to record all the
tracks on deck A.
• The deck may not mark track
numbers for extremely short
tracks.
• You cannot dub an MD when the
RELAY indicator is on. Press
RELAY to turn off the indicator
before starting operations.
2
§
EJECT RELAY MD SYNC
REC MENU/NO ≠ AMS ± YES
r
DISPLAY
A-INPUT
p
A TIME/CHAR
CLEAR
PUSH ENTER
5
1
Press 1/u.
The STANDBY indicator turns off.
2
Insert a recorded MD into deck A and a recordable MD into
deck B.
If the MD has a recorded material on it, the deck will
automatically start recording from the end of the last recorded
track.
3
Select the desired dubbing method.
Check the following table, then go to Step 4.
To perform
All Tracks Dubbing
One Track Dubbing
Program Dubbing
(MD Synchro-Recording)
4
2
§
EJECT
MENU/NO ≠ AMS ± YES
TIMER
B-INPUT
B TIME/CHAR
CLEAR
PUSH ENTER
5
With the arrow pointing this way
Make sure that
the tracks are not selected while deck A
is stopped.
the track is selected while deck A is
playing, pausing or stopped.
the Program Play mode in SET UP
menu "PLAY MODE" is selected while
deck A is stopped (page 29).
Basic Operations
REC
) r
0
·
P p
With the
label side up
(Continued)
EN
11