Safety Instructions; Description; Components; Camera - Extel WESV 87047 SER.R3 Guide D'installation Et D'utilisation

1

SAFETY INSTRUCTIONS

Important !
•
Please read the user manual thoroughly before installing or using this product.
•
If you install this product for other people, please give the manual or a copy to the end user.
Warning :
•
The different elements can only be dismantled by an authorised technician.
Safety instructions :
•
To safely use this system, it is essential the fitters, users and technicians follow the safety procedures described
in this manual.
•
Specific warnings and caution symbols are indicated on the elements if necessary.
•
It is not advisable to install this system in places which are too humid, too hot or too dusty.
•
Avoid the places exposed to high vibrations.
•
The screen must not be installed near a transformer or an electric motor to avoid any interference risks.
•
Dark lines scrolling on the screen indicate interferences.

DESCRIPTION

2
1 • Colour cameras with rotating brackets x 4
2 • cables of 18 m, equipped with plugs to connect the cameras to the monitor x 4
3 • Colour monitor, 18 cm screen with table mounted monitor bracket
4 • 1 remote control unit
5 • One 12 V 5V adapter
Possible option: Additional 20 m cable SV87102 or 50 m cable SVCL 87103 (max camera/monitor width 50 m).
3

COMPONENTS

a. Camera
(fig. 2a)
1. Rain Shield
2. IR LED, with twilight detector (light invisible to the naked eye, for a low-light vision or for night vision, use an
additional lighting system).
3. Camera lens
b. Remote control

1. Camera 1

2. Camera 2
3. Camera 3
4. Cameras 1 and 2 mode
5. Settings -/ previous viewing
6. ON/OFF
7. Camera viewing / VGA mode (not used)
2GB
(fig. 1)
8. Camera 4
9. Automatic camera cycling
10. Cameras 3 and 4 mode
11. Quad-screen
12. Settings +/ next camera viewed
13. Settings selection
CFI EXTEL WESV 87047 SER.R3 - 06/2011 - V1