FMS EXTRA 330 Manuel D'utilisation page 7

Model assembly
Linkage rod installation
1.Make sure the servos are in the neutral position. Attach the
ball link to the elevator control horn's outermost hole using the
included linkage rod. Secure the linkage rod in place using the
included screws as shown.
2.Make sure the servos are in the neutral position. Attach the
ball link to the rudder control horn's outermost hole using the
included linkage rod. Secure the linkage rod in place using the
included screws as shown.
3.Make sure the servos are in the neutral position. Attach the
ball link to the aileron control horn's outermost hole using the
included linkage rod. Secure the linkage rod in place using the
included screws as shown.
KM2*12
KM2*12
PM2*16
7
PM2*16
KM2*12
PM2*16
E
N