Hama CUBE Mode D'emploi page 6

Note – Bluetooth
• Some terminal devices require a
password in order to connect to
another Bluetooth
• If your terminal device requests a
password for connection to the speaker,
enter 0000.
Note – Connection to a new
device
• If you want to connect a new
Bluetooth
terminal device to the
®
speaker, press the Bluetooth
button (2) until the status LED (6)
begins to flash blue and an acoustic
signal sounds..
• The current connection is disconnected
and the search for new terminal
devices starts.
• The speaker always stores the last eight
terminal devices paired.
• The speaker will automatically connect
to the last terminal device paired when
it is switched on the next time.
password
®
device.
®
function
®
4.4 Automatic Bluetooth
(after successful pairing)
• Make sure that your Bluetooth
terminal device is on and Bluetooth
activated.
• Make sure that the speaker is located within
the Bluetooth
range of max. 10 metres.
®
• Switch on the speakers as described in 4.1
Switching the product on and off.
• After successful connection, the status LED
(6) will light up in blue. An acoustic signal
confirms that connection was successful.
Note – Connection impaired
• After the speaker and terminal device
have been paired, a connection
is established automatically. If
the Bluetooth
®
established automatically, check the
following:
• Check the Bluetooth
terminal device to see whether Hama
Cube is connected. If not, repeat the
steps listed under Bluetooth
connection
®
capable
®
is
®
connection is not
settings of your
®
pairing.
®
5