Product Description; Initial Setup - LENCO LS-500 Mode D'emploi

Product Description

Initial Setup

Place the unit on a flat and level surface. The selected location should be stable and free from vibration.
1.
Install the turntable lid to the hinges.
2.
Remove the tie-wrap that is holding the tonearm.
3.
Put the drive belt around the Turntable Hub, and then use the provided belt hoot to help pull the belt to fit
4.
around the slot of motor pulley.
Place the turntable platter through the turntable spindle.
5.
Place the slip mat on top of the turntable platter.
6.
Slide Tonearm Counterweight onto tonearm and twist it lightly onto the rear shaft of the tonearm.
7.
Adjust the counterweight to set proper stylus pressure.
8.
Locate the anti-skating weight
9.
Connect AC-DC adaptor to the Power Jack of the unit.
10.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is completed.
- 5 -