Installation And Service - Thetford Marine TECMA X-light Manuel D'emploi Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation | Installation |Service manual
Manuale di utilizzo | Installazione | Manutenzione
X-light | Privilege | Evolution | Breeze | E-Breeze | Silence Plus 2G | Elegance 2G

3.0 INSTALLATION AND SERVICE

WARNING: Read and understand the warnings listed in this document before installing,
using, or servicing the system. Failure to comply with these warnings may cause injuries,
damage, loss of the property, and electrocution.
Any modification applied to Tecma's product may result in loss of the property, injuries, or
electrocution.
TECMA SRL is not liable for damage, injuries, or death resulting from improper
installation, operations, or interventions.
TECMA SRL recommends entrusting qualified personnel with installing the hydraulic
and electrical systems.
Comply with the system standards in force.
WARNING: Danger of electric shock, fire, or flooding. Failure to comply with these warnings
may result in loss of property, injury, or death. Recommendations:
-
Always use a fuse sized according to the electric circuits.
-
Before starting any maintenance operation, make sure that the power supply is
disconnected and that the seacocks are in the OFF position (closed).
-
If the toilet is connected to a seacock, make sure that its safety valve is always closed
when the boat is unattended, even for a short time.
-
For toilets that use fresh water systems connected (even temporarily) to the port water
mains, make sure that the valve in the quay connection point is always closed when the
boat is unattended, even for a short time.
-
If the Toilet is connected to a seacock, only use marine-type fittings, which must be
secured to every connection with two (2) stainless steel straps. Inspect these straps
frequently to check the seal and, thus, prevent any leaks.
-
If the Toilet is connected to a seacock, install a marine ball safety valve (activated by a
lever) in correspondence of the sea cock.
-
If water fails to flow after the first two/three flushes, there may be an assembly problem
or malfunction. In this case, do not use the toilet and refer to the "Troubleshooting"
section.
Thetfordmarine.com
TECMA S.r.l. | Via Flaminia | Loc Castel delle Formiche | 05030 Otricoli (TR) | Italy
MACERATOR TOILETS
TOILET MACERATRICI
53
Rev. 1 | 2018

Publicité

Table des Matières
loading

Table des Matières