Thetford Marine TECMA X-light Manuel D'emploi Et D'installation page 50

Operation | Installation |Service manual
Manuale di utilizzo | Installazione | Manutenzione
X-light | Privilege | Evolution | Breeze | E-Breeze | Silence Plus 2G | Elegance 2G
Change flushing mode – from mooring mode to sailing mode (Fig.2)
If you have already adjusted the amount of water and now want to go back to sailing mode:
1) Press and hold the BEFORE USE and AFTER USE buttons for approximately 3 seconds.
2) Release both buttons as thelock LED will flash
3) The system is now set to sailing mode
Fig.1
Press and hold for about 3 sec
SAILING
MODE
Fig.2
MOORING
MODE
Press and hold for about 3 sec
NOTE: at the end of the cycle, the toilet remains empty if the system is set in "sailing mode".
Alternatively, a small amount of water remains in the toilet if the system is set in "mooring mode".
Thetfordmarine.com TECMA S.r.l. | Via Flaminia | Loc Castel delle Formiche | 05030 Otricoli (TR) | Italy
Lockout LED starts blinking
Keep pressing and holding for
about 4 sec
Release as soon as the lockout
LED starts blinking
MACERATOR TOILETS
TOILET MACERATRICI
Water starts coming in
Keep pressing and holding the
buttons and release them when
water is in
the desired amount of
the bowl
MOORING
SAILING
SAILING
MODE
Rev. 1 | 2018
MODE
MODE
50