Multiframe Control Panel; One Button; Two Buttons - Thetford Marine TECMA X-light Manuel D'emploi Et D'installation

Operation | Installation |Service manual
Manuale di utilizzo | Installazione | Manutenzione
X-light | Privilege | Evolution | Breeze | E-Breeze | Silence Plus 2G | Elegance 2G

2.2 Multiframe control panel

2.2.1 One button

Press the "AFTER USE" button to start the automatic flush cycle, after which the toilet will be refilled
with a small amount of water, ready for the next use.

2.2.2 Two buttons

Press the "BEFORE USE" button before using the toilet. This will fill the toilet with a small amount
of water. Press the "AFTER USE" button after using the toilet. This will start the automatic flush
cycle, which will empty the toilet.
BEFORE USE
NOTE: It is also possible to adjust the amount of water used during every flushing cycle directly from
the connected remote control unit. A specific regulator placed on its rear increases the amount of
water if turned clockwise, or decreases it if turned anticlockwise. The recommended water level is 1
cm above the ceramic outlet.
WARNING: The tank level LED is only an indicator. Do not use the system if the LED is red.
Thetfordmarine.com TECMA S.r.l. | Via Flaminia | Loc Castel delle Formiche | 05030 Otricoli (TR) | Italy
MACERATOR TOILETS
TOILET MACERATRICI
AFTER USE
TANK LEVEL
AFTER USE
TANK LEVEL
Rev. 1 | 2018
43