Whirlpool AMD 385 Mode D'emploi page 8

WIRE REMOTE CONTROL INTRODUCE
1) Room temperature sensor:
Temperature sensor inside the wire remote control switch is set to sense room temperature, and the
temperature will be sent to indoor unit. When do not connect the wire remote control switch, indoor
unit will switch to the temperature sensor which is built into indoor unit.
2) Wireless remoter receiver:
by this receiver, you can use an additional wireless remoter switch to control indoor unit.
3) ON/OFF button:
press this button to turn on or turn off the unit.
4) MODE select button:
Press this button to select COOLING, DEHUMIDIFICATION, FAN, HEATING or AUTO-RUN mode.
COOLING mode, the air conditioner makes the room cool.
DEHUMIDIFICATION mode, the air conditioner reduces the humidity in the room.
FAN mode, the air conditioner makes the room's temperature suitable, providing the soft air flow.
HEATING mode, The air conditioner makes the room warm.
A
AUTO-RUN mode, The air conditioner runs in right mode according to the temperature of room.
(This mode is invalid for AMD 385)
5) TIMER/SLEEP button:
• Press this button to active sleep mode, and "
Press again to cancel sleep function.
• Press this button for 3 seconds to active timer function.
Press for 5 seconds again to cancel timer function.
For timer function Please refer to timer function introduce.
6) FAN speed/LOUVER button:
• Press this button to change current fan speed. You can select
" "(auto fan speed), "
AUTO
" "(high fan speed) by each press.
WIRE REMOTE CONTROL INTRODUCE
• Press this button for 2 seconds to active LOUVER function.
7) TEMP Setting button:
Press the couple of buttons to set room temperature you want, when you press SET TEMP sign will
appear in LCD, press "
setting temperature.
8) LCD screen
" (low fan speed), " "(medium fan speed),
" button to reduce setting temperature, and press "
" will appear in LCD.
8
" button to increase