Whirlpool AMD 385 Mode D'emploi page 33

Installation of panel
1. Remove the corner pocket cover(4 portions)
1) Pull the fixing hook towards the arrow mark according
the order a,b,c.
2) Lifting the corner pocket cover, move it in "d" direction,
disconnect the L-shaped hook and dismantle the corner
pocket cover.
2. Pull down the U-shaped hook(2 positions) located at the indoor unit side.
3. Set the corner of the refrigerant connection portion of the indoor unit to the position indicated as "Ref.
Piping", and catch the C-shaped hinge(2 positions) onto the U-shaped hook(2 positions) so that
temporary positioning is available.
4. Mount the air panel onto the air panel fixing position by using the fixing screws (M6 long screws).
5. Attach the corner pocket after mounting air panel. (Refer to Fig.4)
1) Catch the band at the rear side of the cover for corner pockets onto the projection of the panel.
2) Catch the L-shaped hook located at the rear side of the cover for the corner pockets onto the
square hole of the air panel.
Band
6. Install corner pocket cover with display.
1) cnnect lines of display part form panel and the water pan wear to the electric contol box.
2) Install corner pocket cover to the panel. (Refer to step 5)
Electrical
control box
Refrigerant pipe
connections
Stamp
"Ref. pipe"
C-shaped hinge
(Q'ty 2)
Projection
33
Fixing hook
a
c
Fixing hook
Indoor unit
U-shaped hook
Fixing plate
Air panel
Long screw
(Q'ty 4)
L-shaped hook
Fixing hook
(3 positions)
Coner pocket cover
b
Fixing hook
L-shaped hook
d
Fig 4