FLAEM Air Pro 3000 Plus Version Mode D'emploi page 16

SOFT TOUCH MASKS
Soft biocompatible
material
Dispersion Limiting Vent
During the inspiratory phase, the
tab, acting as a Dispersion Limiting
Device, bends inwards towards the
mask
USE OF NEBULIZATION MANUAL CONTROL
To achieve continuous nebulisation action you should not use the manual nebulisation control (C6), especially in
the case of children or persons with reduced physical, sensory, or mental capabilities. The manual nebulisation
control is useful for limiting dispersion of the medication in the surrounding environment.
To start nebulizing close with a finger
the hole of the nebulizer manual control
(C6) and breathe in gently; we recom-
mend to hold your breath for a moment
so that the inhaled aerosol droplets can
be deposited,
CLEANING, SANITISATION, DISINFECTION, STERILISATION
Switch off the device before any cleaning procedure and unplug the power cable from the socket.
DEVICE (A) AND TUBING EXTERIOR (B)
Use only a damp cloth with antibacterial soap (non-abrasive and with no solvents of any sort).
ACCESSORIES
Open the nebuliser by turning the upper part (C1.3) anticlockwise, remove the nozzle (C1.2) and the speed selector with
valve system (C1.4) from the upper part (C1.3) as shown in the "Assembly diagram" in point C1.
Then proceed according to the following instructions
CLEANING AT HOME - SANITISATION AND DISINFECTION
SANITISATION
Before and after each use, sanitise the nebuliser cup and the accessories, choosing one of the methods described below.
method A: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4-C5-C6 under potable hot water (approximately 40°C)
with a gentle, non abrasive dish detergent.
method B: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4-C5-C6 in the dishwasher with a hot cycle.
method C: Sanitise accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4-C5-C6 by immersing them in a solution of 50% water
and 50% white vinegar, then rinse thoroughly under potable hot water (approximately 40°C).
If you want to also perform the cleaning for DISINFECTION, jump to the DISINFECTION paragraph.
After having sanitised the accessories, shake them vigorously and place them on a paper towel. Alternatively, dry them
with a jet of hot air (for example, a hair dryer).
DISINFECTION
After sanitising the nebuliser cup and the accessories, disinfect them choosing one of the methods described below.
method A: Accessories C1.1-C1.2-C1.3-C1.4-C2-C3-C4-C5-C6 can be disinfected.
The disinfectant must be an electrolytic chloroxidizer (active principle: sodium hypochlorite) specific for disinfecting,
which is available in any pharmacy.
Implementation:
- Fill a container big enough to hold all of the parts to disinfect with a solution of potable water and disinfectant,
according to the proportions indicated on the packaging of the disinfectant.
- Completely immerse each part in the solution, taking care to avoid the formation of air bubbles on the parts. Leave
the parts immersed for the amount of time indicated on the packaging of the disinfectant associated with the
concentration chosen for the solution.
The new SoftTouch Masks feature an adaptive edge made of a
soft biocompatible material ensuring an excellent adherence
to the face and a Dispersion Limiting Vent. These innovations,
which make them stand out from the rest, allow increased
sedimentation of medication in the lungs and reduced disper-
sion into the air.
During expiration the vent
bends outwards.
meanwhile, to disable nebulizing, re-
move your finger from the hole of the
nebulizer manual control to avoid the
waste of drug, optimizing its acquisition.
Then exhale slowly.
14