FLAEM Air Pro 3000 Plus Version Mode D'emploi page 13

• Do not expose the device to particularly extreme temperatures.
• Do not place the device near sources of heat, in direct sunlight or in excessively hot rooms.
• Do not obstruct or put objects into the filter or its related housing in the device.
• Never obstruct the air vents located on both sides of the device.
• Always use it on a rigid surface that is clear of obstacles.
• Make sure there is no material obstructing the air vents before each use.
• Do not put any objects in the air vents.
• Repairs, including the replacement of the supply cord, are to be carried out by FLAEM authorised personnel only,
by complying with the information provided by the manufacturer.
• The average operating life of the compressor is 2000 hours approximately.
• WARNING: Do not modify this device without authorisation from the manufacturer.
• The manufacturer, the vendor and the importer shall be held responsible for safety, reliability and performance
only if: a) the device is used in compliance with the instructions for use b) the wiring where the device is being used
is in compliance with safety regulations and current laws.
• Interactions: the materials used in contact with medication have been tested with a vast range of medications.
However, in view of the variety and continuous evolution of pharmaceuticals, interactions cannot be ruled out. We
recommend using the medication as soon as possible once it has been opened and preventing prolonged exposure
in the nebuliser cup. The materials used in the medical device are biocompatible in accordance with the provisions of
Directive 93/42 EC and subsequent amendments. However, the possibility of occurrence of allergic reactions cannot be
entirely excluded.
• The manufacturer must be contacted about any problems and/or unexpected events concerning operation and for any
clarifications on use, maintenance/cleaning.
• The amount of time required between preservation conditions and use is approximately 2 hours.
INSTRUCTIONS FOR USE
Before each use, clean hands thoroughly and clean the device as described in the section on "CLEANING,
SANITISATION, DISINFECTION, STERILISATION". During use, it is advisable to protect yourself from any dripping.
It is recommended that each person use their own nebulizer cup and accessories to prevent risk of infection due
to contamination.
This device is suitable for the administration of medical substances and not, for which the administration via aer-
osol is foreseen; these substances are to be in any case prescribed by the Doctor. In case of too thick substances,
the dilution with a suitable physiological solution could be needed, according to the medical prescription.
1. Insert power supply cord (A8) into socket (A7) and then connect it to a mains outlet adequate to the device voltage. The
position of the socket must be such that the device can be easily unplugged from the mains network
1
2
Pour the medication prescribed by the doctor into the bottom part
2.
3. Close the nebuliser by turning the top (C1.3) clockwise.
11
(C1.1)