WOLFF 038587 Mode D'emploi page 12

1
off
on
blade`s width Messerbreite
If the machine is switched on, but the hand clutch is
not engaged, it might happen that the machine runs
slowly "backwards". This is caused by the return stro-
ke of the blade action. It means no failure of the Turbo-
Stripper.
pos. ahead pos. center
without additional weight
TURBO-STRIPPER 230V, Artikel Nr. 038587 ab Masch. Nr. 0001/06
Starting
The Turbo-Stripper is equipped with a power-on indicator lamp
(1) and an operating switch located at the top of the handle. The
switch has a restart protection for low-voltage failures.
If the lamp does not indicate power-on, use another power
socket or check power supply.
If a mains power failure occurs during operation, switch-on the
machine again.
Before starting work, cut the floor covering into strips of about 35
cm (12 inch). You cannot work faster if you cut wider strips.
To begin, cut one strip crosswise.
Then lift the floor slightly in order to get the blade underneath it.
1
6 5 4 3 2
We recommend to cut the first strip at right angles to the main
working direction. By so doing access to the adjacent strips is
made easier.
Cut the strips smaller if the floor covering is bonded very
securely, e.g. with an epoxy adhesive.
The blades are sharpened by the floor pavement. Therefore the
blade only has to be changed if it is twisted, collateral rounded
or becomes worn.
The driving wheels are subjected to wear. They have to be
changed after approximately 16 mm (0.6 inch) of the surface
has been worn away. Otherwise the working angle of the striking
apparatus will not be correct especially critical with cork or foam
backed carpets.
Assembly of support for additional weight (accessory)
Item no. 038535
The weight of the Turbo-Stripper is expandable by 1 up to 3
additional weights (1 single weight = 30 kg).
pos. backward
Individual weight shifting is possible at 3 positions (see picture)."
with 3 additional weights
12