Starting And Stopping - Husqvarna LC48 e Manuel D'utilisation

Starting and stopping

WARNING! Note the following before
!
starting:
Do not start a lawn mower unless the cutter
and all covers are fitted correctly. Otherwise
the cutter could come loose and cause
personal injuries.
Always move the machine away from the
refuelling area before starting.
Place the machine on a flat surface. Ensure
the cutting attachment cannot come into
contact with any object.
Keep people and animals well away from the
working area.
Starting
Ensure the ignition lead sits correctly on the spark plug.
• Pull the engine brake handle against the upper handlebar
with your left hand.
LC48B e and LC53B e
Set the stop switch to the start position.
• Grip the starter handle, slowly pull out the cord with your
right hand until you feel some resistance (the starter pawls
grip), now quickly and powerfully pull the cord. Never
twist the starter cord around your hand.
CAUTION! Do not pull the starter cord all the way out and do
not let go of the starter handle when the cord is fully extended.
This can damage the machine.
LC 53 Ee
LC53Ee are equipped with electronic start which is used in
the following way.
STARTING AND STOPPING
• Before using the electronic start for the first time you need
to charge the battery. See instructions under the heading
Maintenance.
• Fold in the engine brake handle towards the handlebar.
• Insert the ignition key and push the key.
LC48B e and LC53B e
LC48Be and LC53Be are equipped with a blade brake.
To make the cutters rotate, do the following:
• Fold down the brake handle towards the handlebar.
• Move the blade knob to its end position.
Drive
The machines are self-propelling with backwheel drive.
To use the drive on the wheel pull the clutch lever towards
you.
The drive can be gradually controlled.
– 81
English