Starting And Stopping; Check Before Starting; Connect Battery To The Machine - Husqvarna 136LiL Manuel D'utilisation

Check before starting

• Check the motor for dirt and cracks. Clean off grass
and leaves from the engine using a brush. Gloves
should be worn when necessary.
• Check that the trimmer head is completely attached to
the trimmer.
• Check that the machine is in perfect working order.
Check that all nuts and screws are tight.
• Check that the trimmer head and trimmer guard are
not damaged or cracked. Replace the trimmer head or
trimmer guard if they have been exposed to impact or
are cracked. (Figure 29)
• Never use the machine without a guard nor with a
defective guard.
• All covers must be correctly fitted and undamaged
before you start the machine.
• Only use the machine for the purpose it was intended
for.

Connect battery to the machine

Make sure to use fully charged batteries. Use only a
Husqvarna original battery in your machine. See technical
data.
• Insert the battery in the machine. The battery should
slide easily into the battery holder on the machine. If
the battery does not slide in easily, it is not being
inserted correctly. The battery will lock itself into place
when you hear a click. Make sure the battery is fitted
correctly to the machine. (Figure 15)

Starting and stopping

WARNING! Make sure no unauthorised
!
persons are in the working area,
otherwise there is a risk of serious
personal injury. The safety distance is 15
meters (50 ft.).
Starting
Turn on the machine. Press and hold the start button (>1
sec.) until the green LED is lit. (Figure 30)
Stopping
Stop the machine by releasing the power trigger and
deactivate the machine.
Remove the battery from the machine by pressing the two
release buttons and pulling out the battery. (Figure 16)
IMPORTANT! Always remove the battery to prevent the
machine being started by accident.
16 – English
STARTING AND STOPPING