Operation; Setup - Titan PowrCoat Série Mode D'emploi

Operation

4. Operation
This equipment produces a fluid stream at extremely
high pressure. Read and understand the warnings
in the Safety Precautions section at the front of this
manual before operating this equipment.
4.1

Setup

1. Make sure the siphon hose (fig. 5, 1) is connected to the fluid
section (2) and the bleed hose (3) is connected to the bleed
valve (4). They each have factory installed PTFE tape on the
male end of the hoses and should be wrench tight.
i
To orient the siphon hose, loosen the swivel (5) and
orient the siphon tube to the desired location.
2
5
1
2. Lock the gun by flipping the trigger lock into lock position
(see spray gun manual).
3. Using a wrench, attach a minimum of 50' of 3/8" nylon airless
spray hose to the material outlet fitting (fig. 6, item 1) on the
pump. Tighten securely.
4. Fill the oil cup 1/2 full with Piston Lube (P/N 314-480). This
extends packing life.
4
3
1
GB
Piston Lube prevents increased wear and tear to the
packings.
Attention
5. Verify that the air compressor meets the power requirements
necessary to effectively power the sprayer. See "Technical
Data", section 3.4 to determine air requirements.
i
The requirements will vary on each model.
6. Prior to connecting the compressor to the unit, perform the
following in order to prevent accidental startup:
a. Close the shutoff valve (fig 7, item 1). The figure shows the
handle in the closed position.
b. Turn the air regulator (2) fully counterclockwise to its lowest
pressure setting.
c. Open the bleed valve (3) by turning it fully counterclockwise.
The bleed valve handle should be pointing down.
7. Remove the red plug from the air hose fitting (Fig. 8, item 1).
Attach the air hose and tighten wrench tight. All units are
equipped with a 3/4" NPT (M) nipple.
Proper earthing (grounding) is important. The
passage of some materials through the nylon fluid
hose will build up a static electric charge, which if
discharged, could ignite solvent vapors present and
create an explosion.
8
1
2
3
1
PowrCoat