Setup Location Requirements - CASO DESIGN WineComfort 24 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

10.3 Unpacking

10.4 Disposal of the packaging

10.5 Setup

 7 wooden shelves (650, 660)

► Examine the shipment for its completeness and for any visible damages.

► Immediately notify the carrier, the insurance and the supplier about any incomplete

shipment or damages as a result of inadequate packaging or due to transportation.

To unpack the device, proceed as follows:

 Remove the device out of the carton and remove the packaging material.

 Your wine refrigerator should only be moved in an upright position.

 Clean the interior surface with lukewarm water using a soft cloth.

 After at least 12 hours, plugging the appliance into the wall outlet, than place wine bottles

or beverages in the appliance.

► Only remove the blue protective film shortly before setting up the device in the location

where it will be used, to prevent scratches and dirt accumulations.

The packaging protects the device against damages during transit. The packaging materials

are selected in accordance with environmentally compatible and recycling-related

points of view and can therefore be recycled. Returning the packaging back to the

material loop saves raw materials and reduces the quantities of accumulated

waste. Take any packaging materials that are no longer required to "Green Dot" recycling

collection points for disposal.

► If possible, keep the original packaging for the device for the duration of the guarantee

period of the device, in order that the device can be re-packaged properly in the event of

a guarantee claim.

10.5.1