CASO DESIGN WineComfort 24 Mode D'emploi page 33

Attention
14 Troubleshooting
13.3 Moving the appliance
14.1 Safety notices
14.2 Fault indications and rectification of faults
Turn off the appliance first and then unplug the unit from the wall outlet.
Remove all content. Shurely tape down all lose items inside your appliance.
Tape doors shut. Be sure the wine refrigerator stays in the upright position during
transportation.
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
► Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and damages
to the device.
The following table assists in localizing and rectifying minor faults.
Fault
Wine refrigerator
operate.
Your device is not cold enough
or it does not reach the
adjusted temperature:
The light does not work.
Vibrations.
The wine refrigerator seems to
make to much noise
The door will not
properly.
LED could not display.
LED display error - Lo
do not Not plugged in using different voltage. The circuit breaker
tripped or a blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often. The door is not closed completely.
The door seal does not seal properly.
The wine refrigerator does not have the correct clearance.
Defrost the device.
Check the service center.
Check to assure that the wine refrigerator is level.
The wine refrigerator is not level.Check the fan.
close The wine refrigerator is not level.The door is reversed and not
properly installed.The seal is weak. The shelves are out of
position.
Main control board does not work.
PCB Problem. There is some problem with the plug.
Weak quality of display.
Temperature point is out off. Check the service center.
Possible Cause
33