Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12.5 Setup
12.5.1
Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
Place your appliance on a floor that is strong enough to support the appliance when it is
fully loaded.
Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
Ambient temperature below 16°C or above 38°C will hinder the performance of the
appliance.
This unit is not designed for use in a garage or any other outside installation.
Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.
The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 15 cm around the appliance.
Do not cover up any openings on the device and do not block these off.
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.
For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
12.5.2
Legs/feet
There are FOOT (3 bigger feet and 1 small foot).
To level your appliance, adjust the front legs at the bottom of the appliance.
12.5.3
The handle installing
The wine cooler comes with one metal stainless
steel handle. To install simply screw them to the
door with the supplied screws.
To do this, slide the rubber seal on the back of the
door to the side to lay open the predrilled holes.
Use the included screws to install the handle on
the door.
Then reinsert the rubber seal in the correct
position.
30
Publicité
Table des Matières
