Unpacking; Disposal Of The Packaging; Setup; Setup Location Requirements - CASO DESIGN WineMaster Touch 38-2D Mode D'emploi

 7 wooden bottoms
 Operating Instructions with handle and screws (2 handles for 652)
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.

10.3 Unpacking

To unpack the device, proceed as follows:
 Remove the device out of the carton and remove the packaging material.
 Clean the interior surface with lukewarm water using a soft cloth.
 Your wine refrigerator should only be moved in an upright position.
 After at least 12 hours, plugging the appliance into the wall outlet, than place wine bottles
or beverages in the appliance.
► Only remove the blue protective film shortly before setting up the device in the location
where it will be used, to prevent scratches and dirt accumulations.

10.4 Disposal of the packaging

The packaging protects the device against damages during transit. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of
view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer required
to "Green Dot" recycling collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of
a guarantee claim.

10.5 Setup

10.5.1

Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
 Place your appliance on a floor that is strong enough to support the appliance when it is
fully loaded.
caso WineMaster Touch
Please note
Please note
Please note
28