CASO DESIGN WineMaster Touch 38-2D Mode D'emploi page 35

Your device is not cold
enough or it does not reach
the adjusted temperature:
The light does not work.
Vibrations.
The wine refrigerator seems
to make to much noise
The door will not close
properly.
LED could not display.
LED display error - Lo
Bottoms are not functional.
Compressor will not start
Compressor re-start
Dew on the surface of
cabinet：
Liquid sound
caso WineMaster Touch
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often. The door is not closed
completely.
The door seal does not seal properly.
The wine refrigerator does not have the correct
clearance.
Defrost the device.
Check the service center.
Check to assure that the wine refrigerator is level.
The wine refrigerator is not level.
Check the fan.
The wine refrigerator is not level.
The door is reversed and not properly installed.
The seal is weak. The shaves out of position.
Main control board does not work.
PCB Problem. There is some problem with the plug.
Weak quality of display.
Temperature point is out off. Contact the service center.
Temperature controller panel is damaged.
Room temperature is lower than desired temperature.
Compressor will stop working when cooling system in the
cabinet reaches
working until the desired temperature is achieved.
Allow a minimum 5 minute interval before re-starting.
The surface of wine cabinet especially the glass door
appear some frost if item in a damp room. This is due to
the moisture in the air coming into contact with the
cabinet. Please wipe it away with dry cloth.
（1）The sound of compressor when starts or stops
working.
（2）The flowing sound of refrigerant in the refrigeration
system.
（3）The evaporating sound of refrigerant in the
evaporator.
presetting temperature, and re-start
35