Daikin Siesta ATXC25AV1B9 Manuel D'installation page 11

Mounting Installation Plate
Ensure that the wall is strong enough to withstand the weight
of the unit. Otherwise, it is necessary to reinforce the wall
with plates, beams or pillars.
Use the level gauge for horizontal mounting, and fix it with
5 suitable screws for ATXC 25/35 and 7 suitable screws for
ATXC 50/60.
In case the rear piping draws out, drill a hole 65mm in
diameter with a cone drill, slightly lower on the outside wall
(see figure).
ATXC 25/35
Mounting plate
Mounting plate
fixing screw
ATXC 50/60
Mounting plate fixing screw
Recommended Mounting Plate Retention Spots And
Dimensions
ATXC 25/35
« Recommended mounting plate retention spots
(5 spots in all)
104
153
55 207 52
859
Liquid pipe end Gas pipe end
ATXC 50/60
« Recommended mounting plate retention spots
(7 spots in all)
190
Liquid pipe end Gas pipe end
45 91
580 45
1124
Hole with cone drill
Inside
Wall embedded pipe
(Field supply)
Wall hole cover
(Field supply)
Mounting plate
141
Through the wall hole Ø 65mm
Drain hose position
56
181
All dimensions are in mm
173
Through the wall hole
Ø 65mm
Drain hose position
219 48
All dimensions are in mm
Outside
Caulking
Ø 65
Wall embedded pipe
(Field supply)
1-9
Mount The Unit Onto The Installation Plate
Hook the indoor unit onto the upper portion of the installation
plate (Engage the two hooks at the rear top of the indoor unit
with the upper edge of the installation plate). Ensure that the
hooks are properly seated on the installation plate by moving
it to the left and right.
How To Attach The Indoor Unit
Hook the claws of the bottom frame to the mounting plate.
How To Remove The Indoor Unit
Push up the marked area (at the lower part of the front
grille) to release the claws.
Bottom frame
Front grille
Hang indoor unit's hook here.
When stripping the ends
of interconnecting wires in
advance, bind right ends of
wires with insulating tape.
Wire guide
Water Drainage Piping
The indoor drain pipe must be in a downward gradient for
smooth drainage. Avoid situations that are likely to cause
water to leak.
Water Drainage
Water Water
leaking leaking
Correct Wrong Wrong
! CAUTION
• Do not install the unit at altitude over 2000m for both
indoor & outdoor.
Mounting plate
Clip
Mark (Rear side)
Mounting plate
Interconnecting
wires
Water
retention
End
dipped
Water
into
leaking
water
Drain
Wrong