Philips AVENT SCD485 Mode D'emploi page 5

3 Overview
Parent unit (Fig. 1)
a
• Press to turn the parent unit on or off
b link
• In green: The parent unit is linked to
the baby unit.
• In red flashing: The parent unit is
searching for the baby unit.
c Sound level lights
• Indicate the level of sound in your
baby's room
d Speaker
e Connector for the supplied AC/DC adapter
f
• In green: The parent unit is turned on.
• In red flashing: The batteries are low
in power.
volume
g
• Turn to change the volume up/down
• Turn down fully to mute the volume
h Lid of battery compartment
i Three 1.5 V R6 AA batteries (not
included)
j 1 channel 2
• Switch to Channel 1 or Channel 2
k Battery compartment
l AC/DC adapter
• Input: 100-240V AC
• Output: 6.0V DC, 300 mA
• Model number:
SSW-2350AU for Australia and
New Zealand;
SSW-2350PEU for Chile;
SSW-2350UK (3-pin plug) for United
Kingdom, Dubai, and Ireland;
SSW-2350US for Panama and Mexico;
SSW-2350WEU (2-pin plug) for
Dubai and other Western European
countries.
Baby unit (Fig. 2)
a
• Press to turn the baby unit on or off
b on
• In green: The baby unit is turned on.
c Microphone
d
• In green: The baby unit is running on
batteries.
• In red flashing: The batteries are low
in power.
e Connector for the supplied AC/DC
adapter
f Lid of battery compartment
g Four 1.5 V R6 AA batteries (not included)
h 1 channel 2
• Switch to Channel 1 or Channel 2
i Battery compartment
j AC/DC adapter, with the same type as
the one for the parent unit
EN 7