Clock Functions - AEG BP3203121 Notice D'utilisation

10 www.aeg.com
Button
5.6 Heat-up indicator
When you activate an oven function, the
bars in the display

6. CLOCK FUNCTIONS

6.1 Clock functions table
Clock function
Press
switch between the clock
functions.
To confirm the settings of
the clock functions, press
or wait 5 seconds for an
automatic confirmation.
6.2 Setting the DURATION or
END
1. Press
display shows
or flashes in the display.
2. Press
and press
Function
CLOCK
PLUS
come on one by
TIME OF DAY
MINUTE MINDER
DURATION
END
again and again to
again and again until the
or .
or to the set the values
to confirm.
Description
To set a clock function.
To set the time.
one. The bars show that the oven
temperature increases or decreases.
Application
To set, change or check the time of day. Refer to "Set-
ting the time".
Use to set a countdown time (maximum 23 h 59 min).
This function has no effect on the operation of the ap-
pliance. You can set the MINUTE MINDER at any time,
also if the appliance is off.
To set how long the appliance operates. Use only when
an oven function is set.
To set when the appliance must deactivate. Use only
when an oven function is set. You can use Duration and
End at the same time (time delay), if the appliance is to
be activate and deactivate automatically later.
For Duration
and then the hours, for End
set the hours and then the minutes.
An acoustic signal sounds for 2 minutes
after the time ends.
and time setting flash in the display. The
oven stops.
3. Turn the knob for the oven functions
to the off position.
4. Press any button or open the oven
door to stop the acoustic signal.
first you set the minutes
or
If you press when you set
the hours for DURATION
, the appliance goes to
setting of the END
function.
first you
symbol