Air Naturel Sekoa Notice D'utilisation page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.
Storage
• When not using the unit for a long time, after turning off
the unit, wait a day before emptying the tank.
• Clean the unit and the water tank with a white vinegar
based solution.
3.
The product does not work properly
SITUATION
Fault indicator light
The unit does not start.
The dehumidifier does not dry
the air as it should.
The device makes a loud noise
when operating.
Water on the floor.
Lights when there is a problem preventing the proper functioning of the
device. Normally you have to look if the openings are blocked which
could overheat inside the dehumidifier.
lights.
Clean filters.
Check if the camera is not too close to a heat source (eg radiator).
Restart after ten minutes.
Make sure the dehumidifier's plug is pushed completely into the socket.
Do not use an extension cord, connector strip, switched socket or a
continuously adjustable speed controller.
Check the house circuit breaker.
Dehumidifier has reached its preset level or the tank is full.
Tank is not in the proper position.
Allow enough time for the moisture to be absorbed.
Make sure there are no curtains, blinds or furniture blocking the front or
back of the dehumidifier.
Make sure the unit is not too close to a wall.
The humidity control may not be set low enough.
Check that all doors, windows and other openings are securely closed.
Room temperature is too low, below 5°C.
There is a kerosene heater or a steam generating appliance in the room.
The air filter is clogged.
The unit is tilted instead of upright as it should be.
The floor surface is not level.
The hose connection may be loose.
Tighten connections.
CONTINUOUS DRAINAGE FOCUS
• Let the device dry.
• Store in a dry place, preferably in its original packaging.
Avoid high temperatures.
SOLUTION
11

Publicité

Table des Matières
loading

Table des Matières