Recording Using The Serial Remote Terminal - JVC BR-DV3000E Mode D'emploi

RECORDING
Recording can be turned ON/OFF with the serial remote controller or the footswitch connected
to the SERIAL REMOTE terminal on the rear panel.
OPERATE
Mini A.DUB
DVCAM NTSC
PROFESSIONAL
CH-1/3
MIC REMOTE SEL. INPUT SEL.
CH-2/4
SERIAL LINE
9PIN WIRELESS DV Y/C
BR-DV3000
REMOTE SEL. switch
REMOTE (1/2) menu
– – – R E MO T E [ 1 / 2 ] – – –
R E MO T E O N
L O C A L F U N C T I O N A L L K E Y S
P R E R O L L 5 S
R E M F F / R E W M O D E F F / R E W
R E M S T O P S E L E E
P B S T A R T D E L A Y O F
S Y N C H R O N I Z A T I O N O N
N E X T P A G E
P A G E B A C K
Memo
• The serial remote con-
troller can perform op-
erations other than re-
cording.
• The buttons on the unit
to be rendered operable
can be set via the LO-
CAL FUNCTION item of
the REMOTE(1/2) menu.
REMOTE (2/2) menu
– – – R E MO T E [ 2 / 2 ] – – –
C O N T R O L L E R S E L T Y P E 1
F OO T SW O F F
P A G E B A C K
BR-DV3000_E_p03-49

Recording using the serial remote terminal

–
EJECT
MENIU
REC PLAY PAUSE
PAL REC INH.
SET
REW STOP FF
Connection
Connect the serial remote controller (available separately: RM-G30)
or the footswitch to the SERIAL REMOTE terminal on the rear panel.
Setting
Set the REMOTE SEL. switch on the front panel to "SE-
RIAL".
Set the REMOTE item of the REMOTE (1/2) menu to
"ON".
Set the FOOT SW item of the REMOTE (2/2) menu ac-
cording to the way in which the serial remote terminal
is used.
OFF : Set to "OFF" when the serial remote controller is used.
L EDGE : Recording and recording pause operations are
H EDGE : Recording and recording pause operations are
L LEVEL : Record at the LOW edge and pause recording at the
Operation
Before using the footswitch, first engage the recording or recording
pause mode via the buttons on the main unit.
Memo
• The footswitch can only be used for switching the recording
operation ON/OFF.
• The footswitch functions irrespectively of the REMOTE SEL.
switch settings.
41
SERIAL REMOTE terminal
DV IN/OUT
AUDIO VIDEO
Y/C
LINE
CH 1/3 CH 2/4
REMOTE
9PIN
• Serial remote controller: RM-G30
• Footswitch
The footswitch cannot be used.
switched at the LOW edge of the footswitch signal.
switched at the HIGH edge of the footswitch signal.
HIGH edge of the footswitch signal.
13/01/03, 11:37 AM
–
DC12V
NTSC/PAL
SERIAL NTSC PAL
E-41