Adjusting The Daily Filtration Time - cec Line C'EI X Mode D'emploi

Measure the free chlorine level in the pool with your usual analysis kit. The free chlorine should be
greater than 1.5 ppm.
If the free chlorine is less than 1.5 ppm, set the device to 100% position and let it operate
continuously until a sufficient concentration has been reached (from several hours to several days).
When the chlorine level exceeds 1.5 ppm, set filtration to "AUTO".
10

ADJUSTING THE DAILY FILTRATION TIME

Maintenance advice :
It is IMPERATIVE to check the levels of chlorine and pH each week with your usual analysis kit. An
excessive chlorine level and/or a low pH tends to cause oxidation on all metallic parts and can lead to
irreversible deterioration of the pool lining, automatic cover pins and slats, telescopic shelters and heat
exchangers. If you cover the pool (shelter, tarpaulin, cover), ventilate the pool regularly to prevent
dissolved gases accumulating, since these could disturb the measurements of the pH or chlorine probes.
The manufacturer may not be held liable in the event of failure to comply with these operating
instructions
The daily filtration time must be adapted depending of the water
evolution and its temperature.
The device shows on the main screen the recommended filtration
time. Don't forget to follow this recommendation through the
season.
Your device is now ready.
30