Choice Of Languages; Reading The Salt Rate - cec Line C'EI X Mode D'emploi

The salt used should be of standard quality, in pellet or granular form, such as that recommended
for water softeners. It is not necessary to use stabilised salt.
Directly add the salt into the pool (place the bags of salt around the pool) and leave the filtration on
manually for 24 h (the device should be turned off).
3

CHOICE OF LANGUAGES

4
SELFCLEANING OF THE CELL
This device is equipped with an automatic cleaning of the chlorinator cell by polarity inversion of the
cell's poles.
For an optimum cleaning, the inversion frequencies must be adjusted depending on the TH of your
water (water hardness).
Measure the water hardness (TH) with the test trip supplied.
Adjust the inversion frequencies:
MENU
Settings
Options
Languages
Maintenance
3s
5

READING THE SALT RATE

The natural properties of water vary from one pool to another and even over time. To obtain a precise
measurement of salinity, the salt probe must be adjusted at installation and after each reactivation at
the start of the season.
Measure the salt level in the pool with a salt test strip.
Calibrate the salt probe :
MENU
Settings
Options
Languages
Maintenance
You can now turn the device on.
LANGUAGES
French
English
Español
Português
SETTINGS
Inversion frequency
Salt Rate
Actual Water T°
SETTINGS
Inversion frequency
Salt Rate
Actual Water T°
28
Set your inversion
frequency
6 h
4h 8h
40 < TH < 60
Enter the salt rate
measured
4.0 g/l
3,5 4,5
Validation bip
Calibration
OK