Replacing Carbon Brushes; Optional Accessories - Makita 9031 Manuel D'instructions

Installing or removing abrasive belt (Fig. 3 & 4)
Loop the belt over the front pulley. Hold the tool as shown
in the figure and press down to retract the front pulley so
that you can slip the other end of the belt over the rear
pulley. When pressing down the tool, be careful not to
allow the front pulley to turn unexpectedly, causing you to
lose control of the tool.
NOTE:
• The arrow on the inside of the belt and that marked on
the rear pulley must point in the same direction.
Connecting to Makita vacuum cleaner
(Fig. 5, 6 & 7)
CAUTION:
• Always close the nozzle cap when the vacuum cleaner
is not connected to the nozzle. Never insert your finger
into the nozzle.
Cleaner sanding operations can be performed by con-
necting the belt sander to Makita vacuum cleaner.
When connecting to Makita vacuum cleaner, an optional
hose 28 mm in inner diameter is necessary.
When connecting to Makita dust collector (Model 420S),
the hose of the dust collector is not necessary. You can
connect the belt sander directly to the optional hose 28.
OPERATION
CAUTION:
• Secure the workpiece with clamps, etc. if there is any
possibility of it moving during the work operations.
• The tool should not already be in contact with the work-
piece surface when you turn the tool on or off. Other-
wise a poor sanding finish, damage to the belt or loss
of control of the tool may result.
• When working with the tool, be very careful to avoid
any contact of the tool and belt with any part of your
body or anyone or anything near you.
Always use the side grip (auxiliary handle) and firmly
hold the tool by both side grip and switch handle during
operations. Turn the tool on and wait until it attains full
speed. Gently apply the tool to the workpiece surface
and move the tool forward and back. Press the belt only
lightly on the workpiece. Excessive pressure may dam-
age the belt and shorten tool life.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.

Replacing carbon brushes

Remove and check the carbon brushes regularly.
Replace them when they are worn down to the limit
mark. Keep the carbon brushes clean and free to slip in
the holders. Both carbon brushes should be replaced at
the same time. Use only identical carbon brushes.
(Fig. 8)
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps. (Fig. 9)
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Abrasive belts
• Hose 28
NOTE:
• Some items in the list may be included in the tool pack-
age as standard accessories. They may differ from
country to country.
5