Honda HSM1590i Manuel De L'utilisateur page 89

Fuse
In the event of a burned out fuse, replace it with another fuse of the
rated capacity only after investigating the cause for the failure. If the
fuse is replaced without correcting the reason for the failure, the new
fuse may burn out quickly again.
Never replace a burned out fuse with any object other than another
fuse of the rated capacity. Using any other object such as wire or
aluminum foil may cause fires in wiring or other parts.
Block fuse replacement requires specific tools. Ask an authorized
Honda snowblower dealer for replacement.
Fuse replacement (blade fuse only)
1. Remove the rear cover (see page
2. Open the fuse box cover.
3. Replace the fuse as shown.
4. Close the fuse box cover.
5. Reinstall the rear cover (see page
(Blade fuses)
30 A (STARTER)
5 A (MAIN)
FUSE
BOX
COVER
BLOWN BLADE FUSE
The 10 A and 30 A spare
fuses are stored in the
tool bag.
86
5 A (SPARE FUSE)
FUSE
BOX
COVER
10 A (MAIN)
30 A (CHUTER)
3 A (SPARE FUSE)
BLOCK FUSE BOXES
(Consult with your authorized Honda
snowblower dealer for replacement
83 ).
of these fuses.)
).
85
FUSE BOXES
(Open by pushing the right side of
the fuse boxes.)
3 A (ECU)
5 A (SPARE FUSE)
5 A (AUGER CLUTCH)
5 A (HEADLIGHT)
5 A (INDICATORS)