Abus eytron TVVR50011 Manuel Utilisateur page 80

System operation
Connections on the rear of the device
Note
Pay attention to the overview on page 3.
No. Name
Function
8 VIDEO SPOT OUT: BNC video output
When using a HDMI/VGA monitor:
•
No video signal is displayed.
When using no HDMI/VGA monitor:
•
The video spot signal is displayed..
AUDIO SPOT OUT: Cinch audio output
9 MAIN: BNC video output
When using a HDMI/VGA monitor:
•
Video spot signal is displayed.
When using no VGA monitor:
•
The main video signal is displayed.
AUDIO OUT: Cinch audio output (synchronised
with video output)
10 LINE IN 1, 2: Cinch audio input
11 VGA:
VGA monitor connection (9-pin), video output
•
signal
RS-232:
12
Serial port – no functionality
•
13
HDMI
HDMI monitor connection
•
14 LAN:
Ethernet LAN connection
•
15 USB port
16 ALARM IN:
RS-485 connection for PTZ cameras
•
Max. 16 alarm inputs
•
ALARM OUT:
Max. 4 relay outputs
•
17 Connection for earthing line
18 Power switch and mains power connection:
100–240 V AC, 50–60 Hz
•
19 LOOP OUT: Connection for looped video signals
(cable available separately)
20 VIDEO IN: BNC inputs
AUDIO IN: Cinch inputs
Note
All audio inputs have no audio amplifier -> the au-
dio signal has to be amplified before connected.
Therefore you can use a microphone amplifier.
14
Operating elements on the remote control
Note
Pay attention to the remote control diagram on
page 4.
No. Name
Function
21 DEV:
Assigns the remote control with the device ID
22 Alphanumeric keys:
• Selects the camera (channel) in the live view
• Entry of letters and digits in system fields
A:
23
Changes the entry format (upper / lower case,
symbols, digits)
PLAY:
24
Starts playback
VOIP
25
• Not used
PREV:
26
Changes the screen display in the live view
Navigation keys:
27
During playback:
, Sets the speed
•
Previous / next day
• ⊳,
In the live view:
• Selects the camera (channel selection)
In menus:
• Navigation
ESC:
28
• Not used