Mounting The Handle - Makita DUX60 Manuel D'instruction

Indicator
Reverse button for debris removal
WARNING:
Switch off the tool and remove
the battery cartridge before you remove entan-
gled weeds or debris which the reverse rotation
function can not remove. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
This tool has a reverse button to change the direction of
rotation. It is only for removing weeds and debris entan-
gled in the tool.
To reverse the rotation, tap the reverse button and pull
the trigger when the tool's head is stopped. The power
lamp starts blinking, and the tool's head rotates in
reverse direction when you pull the switch trigger.
To return to regular rotation, release the trigger and wait
until the tool's head stops.
► 1 . Reverse button
NOTE: During the reverse rotation, the tool operates
only for a short period of time and then automatically
stops.
NOTE: Once the tool is stopped, the rotation returns
to regular direction when you start the tool again.
NOTE: If you tap the reverse button while the tool's
head is still rotating, the tool comes to stop and to be
ready for reverse rotation.
Electronic torque control function
Mode
High
The tool electronically detects a sudden drop in the rotation
speed which may cause a kickback. In this situation, the tool
automatically stops to prevent further rotation of cutting tool.
To restart the tool, release the switch trigger. Clear the cause
of sudden drop in the rotation speed and then turn the tool on.
Medium
NOTE: This function is not a preventive measure for kickbacks.
Low
ASSEMBLY
switched off and battery cartridge is removed
before carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may result
in serious personal injury from accidental start-up.
completely assembled. Operation of the tool in a
partially assembled state may result in serious per-
sonal injury from accidental start-up.

Mounting the handle

Attach the handle with supplied clamps and bolts. Make
sure that the handle is located between the spacer and
the arrow mark. Do not remove or shrink the spacer.
1
► 1 . Handle 2. Hex socket bolt 3. Clamp 4. Spacer
Attach the barrier (country specific) to the handle using the screw
on the barrier. Once assembled, do not remove the barrier.
► 1 . Barrier 2. Screw
8 ENGLISH
WARNING:
Always be sure that the tool is
WARNING:
Never start the tool unless it is
2
1
5. Arrow mark
3
4
5
3
1
2