Connecting Power; Initial Calibration - OHAUS Scout SKX Série Mode D'emploi

TM
SCOUT SERIES BALANCES - SKX

2.4 Connecting Power

AC Adapter Installation
AC power is used to power the scale when battery power is not needed. First, connect the AC
Adapter (supplied) to the AC Adapter Input receptacle at the rear of the balance then connect
the AC plug to an electrical outlet.
AC Adapter Input Jack
Interface Connection
Battery Installation
Install the four "AA" batteries with polarity as shown in the battery compartment.
Note:
After power on, it is recommended to let the balance warm up for at least 5 minutes before
using it.

2.5 Initial Calibration

When the Balance is first installed, and when it is moved to another location, it must be
calibrated to ensure accurate weighing results. The balance can be manually calibrated with
external masses. Have the appropriate calibration masses available before beginning
calibration. Refer to the Calibration Section for masses and calibration procedure.
Find Quality Products Online at:
Weigh Below Hole
Security Switch
Security slot (Anti-theft lock slot)
Battery Compartment Cover
Figure 2-3. Rear and bottom view of balance
GlobalTestSupply
www. .com
sales@GlobalTestSupply.com
EN-3