Proper Use; Selecting Temperature; Temperature Settings; Automatic Switch-Off - Beurer FW 20 Cosy Mode D'emploi

• The electronic components in the switch of the footwarmer cause the switch to heat up slightly
during use. The switch must therefore never be covered or placed on the footwarmer during
operation.
• Do not pull on, twist or sharply bend the cables.
• Do not stick pins, needles or sharp objects into this footwarmer.
• This footwarmer may not be used by children unless the switch has been preset by a parent or
supervisory person, or the child has been sufficiently instructed on how to use this footwarmer.
• Children should be supervised to ensure that they do not use the footwarmer as a toy.
• This footwarmer must be checked often for signs of wear or damage. If signs of this kind are
discovered, if the cables are damaged or if this footwarmer has been used improperly, it must be
taken either to the manufacturer or the dealer before further use.
• Repairs may only be carried out by specially trained personnel at a repair workshop, as special
tools are required. Incorrect repairs can lead to considerable danger to the user.
• Should you still have questions on using our appliances, please contact our customer service.

2. Proper Use

This product is intended for warming human feet. Do not use the footwarmer while wearing shoes,
as this will decrease your sensitivity to heat and soil the footwarmer. This footwarmer is not intended
for use in hospitals or for commercial applications. In particular, it may not be used for infants, small
children, persons insensitive to heat, helpless persons or animals. The footwarmer may smell of
plastic when used for the first time, but this soon stops.
3. Operation
3.1 Safety
This footwarmer is equipped with a SAFETY SYSTEM. This electronic sensor technology prevents
overheating of the footwarmer over its entire surface by automatically switching off if a fault occurs.
If the footwarmer is automatically switched off by the safety system due to a fault, the indicator lamp
no longer lights up even when the footwarmer is switched on. Please note that the footwarmer can
no longer be operated if a safety-related fault occurs and must be sent in to the specified service
address.

3.2 Selecting temperature

The footwarmer heats up most quickly when you initially set the highest temperature level (level 3). It
can then be turned down again as required.
Of course, the footwarmer can always also be used while switched off, because its 'teddy-bear'
plush will warm the user's feet even if there is no electrical outlet nearby. We recommend switching
on the footwarmer approximately 15 minutes before use to achieve an optimum effect.

3.3 Temperature settings

Level: 0 Off
1 Minimum heat
2 Moderate heat
3 Maximum heat

3.4 Automatic switch-off

The foot warmer switches off automatically after approx.90 minutes, The temperature display starts
to flash or remains on even after switching off (depending on the model). To switch on the foot
warmer again, first set to ‚0' , wait approximately 5 seconds and then select the desired temperature
setting. Switch off the foot warmer (setting ‚0') or unplug it from the mains if you are no longer going
to use the foot warmer after the automatic switch-off.
8