Christopeit Sport AL 6 Notice De Montage Et D'utilisation page 18

Step 3:
Installation of the pedal supports (16) and connecting tubes (24).
1. Place the preassembled unit of the right pedal support (16) and one
connecting tube (24R) at the right hand side of the main frame (1).
(Note: Right is specified as viewed standing on the machine during
training.)
2. Put one wave washer (26) onto the pedal crank (21).
3. Push the connecting tube (24R) onto the axles' end of handlebar support
(38) and put the pedal holder (16) at the pedal axle (21) at the same time.
Put on the screw (27) a washer 8//32 (13) and tighten the connection
tube (24R) at handlebar post (38) firmly. Then tighten the pedal support
holder (8R) at pedal crank (21) with washer 10//32 (45), spring washer
( 9) and self locking nut (10).
4. Cover nut (10) with a screw cap for M10 (11) and screw (27) with screw
cap for M8 (22).
5. Install the left pedal support (16) incl. all additionally required parts on
the left hand side of the machine as described in 1. – 4.
6. Mount front pedal support cover (37L+37R) to both side front end of
pedal support (16) and secure with screws (25) for each side.
Step 4:
Installation of pedals (18L+18R) at pedal support (16).
1. Push the right pedal (18L+18R) onto the right pedal holder (16). Adjust
the holes in the parts so that they are aligned.
2. Push the screws (19) from above through the holes. Push on a washer
(14) from the opposite side and screw on a nut (50) and tighten firmly.
(Note: The right and left footrests (18) can be discerned by the edges of
the longitudinal sides of the footrests. The high edges of the footrests
(18) must point inwards (towards the main frame.)
Step 5:
Installation of the hand grips (28) at the connecting tubes (24).
1. Put the handgrip bars (28L+28R) onto the connecting tubes (24) and
adjust the holes in the tubes so that they are aligned.
(Note: the handgrip bars must be aligned after assembly so that the
upper ends are inclined outwards (away from the support (38)).
2. Push the bolts M8x16 (39) through the holes and tighten the handgrip
bars (28) with curved washers 8//19 (49) and spring washers (42) at
connection tubes (24) firmly.
3. Connect the plugs of pulse cables (34) and pulse connection cables
(32).
18