Risk Of Injury In Case Of Improper Work; Danger Caused By An Uncontrolled Escape Of Hot Fluids; Risk Of Burns Due To Hot Components And Surfaces; Availability Of The Operating Instructions - oventrop Unibox TQ RTL vario Notice D'utilisation

Unibox TQ RTL vario
Sanitary, heating and air-conditioning
specialists
Sanitary, heating and air-conditioning spe-
cialists are able to carry out work on heat-
ing and cooling systems as well as potable
water systems as a result of their professional
training, expertise and experience, as well as
their knowledge of the relevant standards and
regulations. They must be able to independent-
ly identify possible dangers.
2.5.2 Risk of injury in case of improper
work
Angular components, protrusions and edges
both inside and outside the product may cause
injuries.
f Before starting work, make sure that there
is sufficient space.
f Handle open and sharp-edged compo-
nents with care.
f Make sure that the workplace is tidy and
clean to avoid accidents.
2.5.3 Danger caused by an
uncontrolled escape of hot fluids
f Only carry out work when the product is
depressurised.
f Allow the product to cool down before
working on it.
f Check that the product is not leaking after
work is complete.
f If necessary, cover the vent holes with a
cloth as appropriate.
f Replace any defective fittings immediately.
f Wear safety goggles.
2.5.4 Risk of burns due to hot
components and surfaces
f Allow the product to cool down before
working on it.
f Wear protective clothing to avoid unpro-
tected contact with hot system compo-
nents and fittings.
102273680-V01.07.2019
Safety-related information
2.5.5 Availability of the operating
instructions
Any person working on this product has to
read and apply these operating instructions
and all other valid documents (e.g. accessory
manuals).
The operating instructions must be available at
the installation location of the product.
f Hand these operating instructions and all
other relevant documents (e.g. accessory
manuals) over to the user.
2.5.6 Danger to life due to electric
current
Work on the power supply may only be carried
out by a qualified electrician.
f Check that no voltage is present.
f The product must only be installed in dry
indoor areas.
29