Safety Instructions Akku / Battery; Hazard Warnings; Rotating Parts - Zipper Maschinen ZI-BRM52EST Manuel D'utilisation

15.7

Safety Instructions AKKU / Battery

 Vapours may escape if used improperly or if the batteries are damaged. Supply fresh air and
consult a doctor if you have any complaints. The vapours may irritate the respiratory tract.
 DANGER OF FIRE! Never charge batteries in the vicinity of acids and highly flammable
materials.
 Only charge the battery in an ambient temperature between 0°C and +40°C. Allow the
battery to cool down after heavy charging.
 DANGER OF EXPLOSION! Protect battery from heat and fire.
 Only use the battery in an ambient temperature between 0°C and +45°C.
 DANGER OF SHORT CIRCUIT! For disposal, transport or storage the battery must be packed
(plastic bag, box) or the contacts must be taped.
 Never open the battery
15.8

Hazard warnings

Despite intended use, certain residual risks remain.
Remaining risks:
 Risk of injury due to noise:
Working for a long time can damage your hearing if you do not have a very good hearing protection.
 Risk of injury due to the working area:
Solid objects, stones, metal parts, or the like can be thrown out!
 Risk to the hands or fingers:
Do not grab in the cutting tool while it is rotating.
 Risk of injury due to pick up and roll up:
Wires and cords can be detected by the cutting tool and can damage the machine and can cause
injuries. Unplug battery and safety switch (if equipped) before removing the deposits!
 Risk of injury due to vibration:
The declared vibration emission value has been for a standardized test is measured and can be used
to compare one tool with another electric are.
The declared vibration emission value may also be used for a preliminary assessment of exposure.
Warning: Emission level of vibration can be different from the specified value during the actual use
of the electric tool, depending on the manner in which the power tool is used. When you feel
uncomfortable or notice discoloration of skin on your hands during the use of the machine, stop
working immediately. Observe sufficient break times to rest. Failure to have sufficient break times
may result in a hand-arm vibration syndrome.
The extent of exposure depending on the type of work or machine use should be estimated and
appropriate breaks taken. In this way, the extent of exposure can be considerably reduced over the
entire work time. Minimize the risk caused by vibrations. Maintain this machine according to the
instructions in the manual.
 Rotating parts
Be rotating parts (blades) mounted incorrectly, this can lead to serious accidents.
Check before starting work, the cutting blade for tight fit
 Risk of burns:
Touching the mufflers, exhaust and other machine components which can be hot after prolonged
continuous operation or when the engine is hot cause severe burns.
 Risk of fire and explosion:
Gasoline is highly flammable and explosive under certain conditions.
NEVER refuel fuel or engine oil while the machine is in operation or is hot.
When refueling and at places where fuel is stored not smoke or allow open flames or sparks.
Do not overfill the fuel tank and avoid the spillage of gasoline during refueling. If fuel is spilled make
sure the area is completely dry and cleaned before starting the engine.
Make sure that the filler cap is tightly closed again after refueling safely.
 Chemical risks:
Never use or refuel a gasoline or diesel engine in a closed area without adequate ventilation.
Carbon monoxide emissions from the internal drive units of the engine can cause in confined spaces
through inhalation health effects and death. Therefore use the machine only in well-ventilated rooms or
outdoors in operation.
Liquid fuels can cause serious damage on the skin and the environment.
ZIPPER MASCHINEN GmbH
ZI-BRM52EST
www.Zipper-Maschinen.at
SAFETY
25