Operating Instructions; Charging The Battery For E-Start; Operating; Installing Grass Box - Zipper Maschinen ZI-BRM52EST Manuel D'utilisation

Masquer les pouces Voir aussi pour ZI-BRM52EST:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Spare the engine for the first 20 operating hours (this also applies to used engines after
extensive maintenance). This means lower speed and lower maximum working load than
during normal operation.
Change the engine oil after the first 20 hours of operation.

17.2 Operating instructions

Never tighten the cable while the engine is running. This will damage the motor.
The pull mechanism for changing the motor speed is limited by an adjusting screw. This is
factory set. Never change this setting on your own, you could overload the motor.
Under no circumstances should you operate the machine on slopes of more than 20°, as
even with an optimum oil level the engine may not be supplied with sufficient lubrication.
In the direction of the forward movement of the machine and within a range of one meter
around the machine, nobody but the operator must stand.
Pay particular attention to the following particularly dangerous areas:
Special precautions must be taken when mowing on slopes. Only mow crosswise to the
slope, never downwards or upwards, observing the maximum permissible slope angle.
The cutting height can be adjusted by means of a lever on the machine, adjust it to the
respective condition of the lawn to be worked.

17.2.1 Charging the battery for E-Start

17.3 Operating

17.3.1 Installing grass box

ZIPPER MASCHINEN GmbH
ZI-BRM52EST
 Connect the charger to the power supply (AC outlet) 230 V / 50 Hz
 Connect the charger with the battery
 Charge the battery
 Once the battery is fully charged disconnect the battery and the
charger
LED- indicator light:
LED blinkt Grün: Akku wird geladen
LED leuchtet Grün: Akku vollständig
geladen
LED blinkt Rot: Akku oder überhitzt
oder Sicherung ist defekt
LED leuchtet Rot: Kundenservice
kontaktieren
 Open the rear discharge door.
 Lift the grass box by its handle and place under the rear door, so
that the hooks on the grass box frame are seated into the slots
provided in the handle bracket. . Release the rear door. When
installed correctly, the grass box will fit snugly against the rear of
the mower and the rear discharge door will fit into the recess in
the top of the grass box.
Indicator grass box:
The grass box has an indicator on the side of the box.
If the indicator is lifted when mowing the grass box is empty.
If the indicator is closed the grass box must be emptied.
www.Zipper-Maschinen.at
Battery status light:
Durch Drücken der Akkuprüftaste (1)
neben der Akkuanzeige (2) kann der
Ladezustand des Akkus geprüft
werden.
4 x LED = vollständig geladen
Wenn keine LED mehr leuchtet, Akku
aufladen
OPERATION
29

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

9120039233154

Table des Matières