HOLZMANN MASCHINEN KAM215EPSV Mode D'emploi page 39

HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
1. Assembly workpiece plate support
Assemble the workpiece plate support
(1) by means of screws (3) at points
A and B on the guide rods (2) of the
machine.
2. Assembly edge band support plate
Assemble the arm (1) to the machine with
the four cap screws (S).
Insert the table fixation (2) into the hole
in the arm (1) and secure it with screws
(S1). Now loosen the cylinder screws (S2)
and remove the holder (3). One ball bear-
ing (L1) should remain on the table fixa-
tion (2) and the second L2 in the holder
(3). Place the supporting table (4) on top.
Place the bearing L2 from the holder (3)
on the supporting table and then remount
the holder (3) with the screw (s2). Deflect
the 2 struts of the table mounting at 90°
to the plate and mount the limiting rollers
(6).
NOTICE
Some components are located in
the machine body and can be
removed after opening the pro-
tective cover.
3. Assembly dust collector hoses adapter
Attach the two adapters (1) of the
dust collection system, one for the
pre-milling unit at position (A) and
one on the double trimming unit (B)
to the machine using the screws (S)
and nuts (M)..
ASSEMBLY
39
KAM215EPSV