Haier HRB15N3 Instructions D'installation Et Guide De L'utilisateur page 8

3. Using a Phillips screwdriver, remove the four screws attaching
the wiring cover to the top of the refrigerator cabinet. Lift up on
the wiring cover and allow it to rest on the top of the cabinet.
a
4. Disconnect the wiring harnesses, by pinching each end and
gently pulling them apart. Set wiring cover aside.
a
a
Wiring Harnesses
b
Wiring Cover
5. With your thumbs in the opening next to the hinge, press
upward on the top plate to release and remove it from the
refrigerator door. Set the top plate aside.
a
6. Lift up to remove the hinge cover, and keep it for possible future
use.
a
Hinge Cover
6
a
Screws
b
a
Top Plate
a
7. Using an 8 mm socket wrench, remove the two screws attaching
the top hinge to the cabinet.
8. Slide the top hinge to disengage it from the third screw on the
cabinet, and then lift up to remove the hinge pin from the door.
NOTE: Save the top hinge for possible future use.
9. Lift the refrigerator door off of the center hinge, and gently lay
the door on a covered surface.
10. Using a Phillips screwdriver, remove the plastic door closure and
the metal door stop from the bottom of the door.
a
b
a
Door Closure
b
Door Stop
11. Remove the screw from the door closure, and replace the screw
into the hole from which it was removed.
12. Move the door stop to the opposite side. Insert screw into the
center hole and fasten.
a
Screw
b
Door Stop
a
b