WUNDER RS Guide Rapide page 23

ENGLISH
RF Emission CISPR11
Harmonic emission
Voltage fluctuations/
emission
Guide and Statement of manufacturer-Electromagnetic Immunity
The electronic scales RS model is scheduled for operation in the electromagnetic environment specified below. The
customer and the user should ensure that it is used in that environment.
Immunity test
Electrostatic discharges
(ESD)
IEC/EN61000 - 4 -2
Rapid transients/burst
IEC/EN61000 - 4 - 4
Surge
IEC/EN61000 - 4 - 5
Voltage dips, short
interruption and voltage
variation
IEC/EN61000 - 4 - 11
Power frequency Magnetic
field IEC/EN61000 - 4 - 8
CAUTION: The medical device requires particular electromagnetic compatibility precautions and must be
installed and used according to the information provided in the accompanying documents.
Manufacturer's guide and declaration - Electromagnetic emissions
The electronic scales RS model can be used in the electromagnetic environment specified below. The customer or
the user must ensure that it is used in compliance with the specifications below.
Emissions test
Radiated/ conducted /
emissions
IEC/EN61000-4-6
RS RÈV.07 12/02/2019
Group 1, Class B
Class A
flicker
Compliant
Compliance
6kV in contact
8kV in air
2kV power supply
1kV differential mode
<5%UT for 0.5 cycle
40%UT for 05 cycle
70%UT for 25 cycle
<5%UT for 5 sec
3A/m
Compliance
3Vrms 150kHz to 80MHz (for
appliances that are not life
supporting)
The scales RS is suitable for use in all sanitary and
hospital buildings, connected to the low voltage public
power supply network.
Guide to electromagnetic environment
The floors should be made of wood, concrete or
ceramic. If the floors are covered in synthetic material,
the relative humidity should be maximum 30%.
The power supply should be of the type used typically
in commercial or hospital environments.
The power supply should be of the type used typically
in commercial or hospital environments.
The power supply should be of the type used typically
in commercial or hospital environments. Note=UT is
the value of the voltage of the feed.
Guide to electromagnetic environment
Equipment in RF communications and mobile
laptops should ot be used near any part of the
tooth, including cables, except when they meet
23