Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing the appliance
Each appliance is carefully checked under operating
con ditions before leaving our factory. Any moisture or
water residue which you may possibly find in the
appliance or outlet hose are attributable to this check.
Installation area
In order to ensure the stability of the appliance during
spin drying, the installation area must be firm and level.
Soft floor coverings, e.g. fitted carpets or coverings with
a foamed material backing are not suitable as an instal
lation area.
On timber joist floors, place the appliance on an at least
40 mm thick, waterresistant timber board which should
be screwed firmly to the floor. Installation should be made
as far as possible in the corner of the room.
If it is attached to a stand, the base of the device must
be fixed securely to it with a fixing set in order to prevent
it from sliding off during its spin cycle.
You can purchase the fixing set as a kit at your specialist
retailer or through our customer services team:
Steel fixing set – to be drilled: Order No: S110
Plastic fixing set – to be glued: Order No: 51215
Aligning the appliance
In order to ensure the machine's stability, it must be in a
vertical position with all four feet firmly on the floor and
it must not wobble. Otherwise the machine might move
during operation and cause any damage.
X Aligning the appliance with the help of a spirit level
on all sides.
32
E
X If necessary, correct the height of the appliance feet.
1.
Loosen the counternuts.
2.
Correct the height of the feet.
3.
Tighten the counternuts firmly again so that the foot
heights set will be maintained.
Publicité
Table des Matières
