Hama 00040074 Mode D'emploi page 5

4. Getting started – installing the Batteries
Note
• Alkaline batteries are recommended. Use
2 „AAA" (LR 03/Micro) type batteries.
• Remove the battery compartment lid on the back of your URC (A).
• Check the required battery polarity and insert batteries according to the
"+/–" marks inside the compartment (B).
• Close battery compartment lid (C).
Note: Code saver
• Any code you have programmed or any key you have learned will remain
stored even during replacing of the batteries.
Note: Battery saving function
• Die Fernbedienung schaltet sich automatisch aus, wenn eine Taste länger
als 15 Sekunden gedrückt wird. Dies verlängert die Lebensdauer der Batte-
rien, sollte die Fernbedienung an einer Stelle feststecken, an der die Tasten
dauerhaft gedrückt werden, z. B. zwischen Sofakissen.
Note: Low Battery Indication
• This remote is equipped with a low battery indication.
If the LED indicator ashes 5 times after any button has been pressed, the
batteries are low and need to be replaced soon.
5. Setup
Note
• To obtain a proper infrared (IR) transmission, allways point your Remote
control in the approximate direction of the device you want to control.
• No entry for approx. 30 seconds will time out the Setup mode. The LED
indicator shows three ashes and turns off.
• Each device type can be programmed under any device key, i.e a TV can be
programmed under [DVD], [AUX], etc.
• If you want to control a device , it´s not possible while the Universal Remote
Control is in the Setup Mode. Exit the Setup mode and select the device you
want to control using the device selection keys.
• While pressing any key of the remote one of the device key LEDs is ashing
indicating the active device mode.
3