ARTHUR MARTIN AW6F3844BB Notice D'utilisation page 30

30
Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the table). If the problem persists,
contact the Authorised Service Centre.
In case of major problems, the acoustic
signals operate, the display shows an
alarm code and the Départ/Pause
button may flash continuously:
• - The appliance does not fill with
water properly. Start the appliance
again by pressing Départ/Pause
button. After 5 seconds the door will be
unlocked.
• - The appliance does not drain
the water.
• - The appliance door is open or
not closed correctly. Please check the
door!
If the appliance is
overloaded, remove some
items from the drum and/or
hold the door shut while
touching the Départ/Pause
button until the indicator
stops flashing (see the
picture below).
Possible failures
Problem
The programme does
not start.
•
•
Possible solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that the appliance door is closed.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the Départ/Pause has been touched.
• If the delay start is set, cancel the setting or wait for the end of
countdown.
• Deactivate the Child Lock function if it is on.
• Check the position of the knob on the selected programme.
- The mains supply is unstable.
Wait until the mains supply is stable.
- No communication between
electronic elements of the appliance.
Switch it off and switch on again. The
programme was not finished properly
or the appliance stopped too early. If
the alarm code appears again, contact
the Authorised Service Centre.
WARNING! Deactivate the
appliance before carrying out
any check.