Nimh/Nicd Battery Program; Charging Nicd/Nimh Batteries; Discharging Nicd/Nimh Batteries - Venom Group International Medion Dual 10 amp Manuel D'utilisation

NiMH / NiCD BATTERY PROGRAMS
NiMH/NiCD BATTERIES
These battery charge profiles for NiMH (Nickel Metal Hydride) or NiCD (Nickel
Cadmium) batteries are commonly used in R/C vehicle applications. To alter the
value on the display, press Start/Enter button to make it flash then change the
value using INC or DEC button. The value will be stored by pressing the Start/
Enter button once.
To start the charge process, press Start/Enter button for more than 3 seconds.
CHARGING NiCD/NiMH BATTERY
The screen shows the real-time progress during charge. To stop charging, press
Batt Type/Stop button once.
discharge. You can alter the discharge current by pressing Start/Enter button
during the process. Once you change the current value with the INC or DEC
button, store it by pressing the Start/Enter button again. To stop discharging,
press Batt type/Stop button once.
dual 10 amp
For this program, only the charge current needs to
be set. In "Aut" mode, you need to set the upper
limit charge current to avoid too high of charge
current that may damage the battery. Some
batteries of low impedance and small capacity can
lead to the higher charge current by the processor
at the automatic charge mod. In "Man" mode, it
will charge the battery with the charge current set
by the user in the display screen. Each mode can
be switched by pressing the INC and DEC button
simultaneously when the current field is blinking.
DISCHARGING NiCD/NiMH BATTERY
Set discharge current on the left and the final
voltage on the right. The discharge current ranges
from 0.1-5A and the final voltage ranges from 0.1-
25V. To start the process, press Start/Enter button
more than 3 seconds.
Typical discharge voltage for NiCD/NiMH batteries
is .85V per cell for NiCD, and 1.0V per cell for NiMH.
For 6 cell NiCD's it is .85 x 6 = 5.1V final voltage.
The screen shows the real-time progress during
[ 16 ]